System Description
The Petersen PL-3 Lightning Loader and 18 foot, 24 cubic yard body are mounted on a steel skid. Heavy-duty steel rollers on the rear of the body allow for easy installation and removal of the unit. Loader is hydraulically locked to the chassis. The Pl-3 is intended for cable style roll-offs. For hooklift style roll-offs, please inquire about the Petersen model HL-3.
General
Reach (from centerline rotation): 20 feet
Main Boom and Tip Boom: 16 feet
Tip Extension: 4 feet
Unit Weight (empty): 11,500 lbs
Outrigger Span: 11’8″
Storage Height (above vehicle): 8’4″
Lifting Capacity
10 Foot Radius: 7,100 lbs
16 Foot Radius: 4,400 lbs
20 Foot Radius: 3,200 lbs
Weight of bucket and/or attachments must be subtracted from lift capacities shown. Standard bucket weighs appx. 1000 Ibs. Capacities shown do not exceed 85% of vehicle tipping moment with outriggers fully extended on firm, level ground.
Bucket Features
All purpose clamshell design, 4 feet wide with an opened width of 5 feet. Replaceable bolt-on bucket blades made of high impact tempered steel. Anti-scalping bucket sides are pivot mounted to provide a horizontal closing action rather than a vertical digging motion. Sides are mechanically linked to single hydraulic cylinder to ensure both sides close and open together. Continuous rotation. No hoses below bucket rotator.
Chassis & Hoist Requirements
The Petersen PL-3 loader system requ ires a heavy-duty chassis & roll-off hoist. The complexity of the system and diversity of chassis/hoist combinations available necessitates that Petersen check each one individually prior to sale. The following are minimum requirements:
|
18 ft. 24 cy |
20 ft 26cy |
| GVW |
60,000 (tandem) |
60,000 (tandem) |
| Cab to Trunion |
174 |
194 |
| Hoist Capacity |
50,000 lbs |
50,000 lbs |
| Rail Length |
22ft 6in |
24ft 6in |
These are not complete chassis specifications. Call your Petersen representative about other possible chassis arrangements and for complete chassis specs.
Trash Body
18 feet, 24 cubic yard capacity is standard size (larger size available for 24.5 ft rails).
3/ 16~ solid plate floor on cross members with 12″ centers.
Operator Controls
Dual manual controls (greaseless) for outriggers and loader on both sides of truck for easy access and visibility. A “Grip Strut” serrated steel walk platform and steel handrail is included. Frame lock control lever is located at valve bank. Also available with QuadStick controls (mechanical six-function joysticks).
Structural
A-frame pedestal design allows flexing under repeated load shocks. Replaceable Cast Nylon Bushings used in head assembly. Head assembly is stress relieved. Reinforced connection points with hardened pins and replaceable bushings. Counterbalance valves used on all boom cylinders and pilot operated check valves used on vertical outrigger cylinders.
